What do we calculate?
In the heat-load calculation we work out what output you need, how much fuel you will use and which plant suits you – boiler, fuel store and accumulator tank.
The right output is the foundation. A boiler that is too small will not be enough on the coldest days, and one that is too large spends much of its time at low load. The heat-load calculation gives you a basis for comparison with what you have today, before you decide.
What we need to know.
- What needs heating. The buildings and premises, and whether the heat will also go to hot water, drying or a process.
- How you heat today. Your current boiler or heat source, and its consumption if you have the figures.
- The fuel. Which wood chips, which pellets or which other fuel you can get hold of.
- The site. Where the boiler and fuel store can stand, and how you want to fill the store.
Six steps to heat.
- 01
Needs analysis
We go through your heating needs, your fuels and your premises. The heat-load calculation is free of charge.
- 02
Design and engineering
Calculations, 3D drawings in IRONCAD, system documentation, and engineering and design drawings.
- 03
Manufacturing
We manufacture screws, fuel stores and our own plants ourselves, adapted to your particular site.
- 04
Installation
Assembly, commissioning and fine-tuning – the plant is handed over ready to run.
- 05
Training
We teach you how the plant works and provide operation and maintenance manuals.
- 06
Service
Once or twice a year, with alarms, remote monitoring and remote control.
The whole project, or parts of it.
The boiler room is drawn in 3D and 2D with heating, plumbing and electrical drawings, and at commissioning you receive documented training. We can take on the whole project as main contractor, with buried pipework, chimney and substations, or just parts of it – local plumbing and electrical firms can also do the installation.



