Skip to content
Biotherm Heat AB – to the home page Contact
+46 (0)921-578 00info@biothermheat.com

Guide 06The fuel

Choosing the right fuel

The fuel determines which boiler, which fuel store and which output range will suit you. Start from what is close at hand.

Reading time approx. 2 minAll guides in the knowledge base

Symbols for seven biofuels in blue light on a reflective floor: wood chips, pellets, firewood, logging residues, sawdust, briquettes and peat

Eight biofuels.

Bioenergy is fuel from the plant kingdom. Most of it comes from forestry and the forest industry – but horse manure can also become heat.

Fuels, output ranges and what is good to know
FuelOutput rangeGood to know
Wood chips20 kW–4.6 MWFinely chipped wood from the less valuable parts of the tree. One of the cheapest ways to heat, but wood chips need space – the fuel store and feed system are carefully planned.
Pellets20 kW–4.6 MWPressed from dried and ground sawdust and other by-products. Even and dry, easy to automate. Stored in small bags, big bags or bulk.
Firewood10–100 kWFor the farm and the smaller property. Multiauto can burn firewood in the upper part of the firebox, together with wood chips or pellets.
Horse manure250–1,000 kWBurned in the Biotherm burner, developed with Luleå University of Technology. It handles horse manure with up to 60 % moisture content.
Logging residues–Felling residues: branches and tops. Recovered as wood chips at final felling.
Sawdust–Sawdust and bark from sawmills. The sawdust can be pressed into pellets or briquettes.
Briquettes–Dry sawdust or wood shavings pressed without additives. The wood's own lignin binds it together.
Peat–Sod peat is peat pressed into pieces. It is often burned together with other wood fuels.

The output range applies to our boilers for each fuel. We work out the right size for you in the heat-load calculation.

How to choose a fuel.

  • Start from what is close at hand. Your own forest, a sawmill nearby or a local chip supplier – short transport distances make the fuel cheaper.
  • Think about the space. Wood chips take up roughly four times as much space as pellets for the same heat, and the fuel store needs to be close to the boiler.
  • Think about the work. Pellets are even and dry and easy to automate. Wood chips are cheaper but need a larger fuel store.
  • Think about the output. Firewood suits the smaller property; wood chips and pellets cover everything from 20 kW up to 4.6 MW.

One boiler, several fuels.

Today's plants are built for several biofuels. Multiauto burns wood chips, pellets and firewood – but also sawdust, wood shavings, logging residues, peat and residues. The IDRO industrial boiler burns dry and wet fuels, even of lower quality, and has bio-oil as a backup in the same boiler body.

That gives you peace of mind: if a fuel becomes expensive or hard to get hold of, you can switch to another.

Read next

More guides.

All guides in the knowledge base

Free heat-load calculation

Let's calculate your heating.

Tell us what needs heating and we will calculate it for you – the heat-load calculation is free of charge.

Call +46 (0)921-578 00

info@biothermheat.comVästerås · Luleå

Free heat-load calculation

Let's calculate your heating.

Tell us briefly about your plant and we will get back to you. The first step is free of charge.

We use your details to handle your enquiry. Read our privacy policy.

Cookie settings

Choose what may be loaded and stored.

Read more in the privacy policy